Bamboo – Fastboy Knowledge Base https://fastboykb.site Mon, 27 Oct 2025 14:16:54 +0000 en-US hourly 1 https://wordpress.org/?v=6.9.4 Paper Jam Caused by Unremoved Protective Film https://fastboykb.site/papper-jam-by-film/ Fri, 17 Oct 2025 22:02:42 +0000 https://fastboykb.site/?p=163 Issue Description:
Printer experienced a recurring paper jam issue where the paper was being pulled and wrapped around the roller. Root Cause:
Upon inspection after device return, it was found that a clear plastic protective film located near the metal bar adjacent to the roller had not been removed during setup. This caused paper to stick and jam during printing. Resolution: 
  1. Removed the clear plastic protective film near the roller.
  2. Cleaned any remaining adhesive residue to ensure smooth paper feeding.
  3. Tested the printer confirmed normal paper feeding and printing operation.
Preventive Action / Training Note:
  • During installation or maintenance, always check and remove all protective films around rollers and internal mechanical parts.
  • Ensure the roller area is free from adhesive residue or debris before testing.
Conclusion:
Removing the unpeeled plastic film resolved the paper jam issue completely.

]]> Adjust Fan Speed Tutorial For Bamboo B10 https://fastboykb.site/b10-adjust-fan/ Wed, 01 Oct 2025 20:25:53 +0000 https://fastboykb.site/?p=154 
  • BIOS Configuration. ( Click & spam "DELETE" key to get into BIOS setting)
    • 

A. Access Advanced Settings.

1. Navigate to Advanced tab.

2. Go to Hardware Monitor (located at the 5th line).



3. Set:
    • Go to "FAN Speed Step" to adjust fan speed.
    • Set fan speed at "70%" then hit Enter.
    

4. Finalize press "ENTER" and "YES" to save configuration.



After all, Fan speed will spins faster than normal that give B10 device a better performance.

* Note Do NOT put as maximum fan speed will cause consume power system board.

* Noise might louder than normal.
    ]]>